Cutting down a CPET Test

If a test continued for longer than you need, or you have a long trailing end you can follow these steps to reduce the test graphics.

Please note only the graphic is cut short presently. All remaining test data will still show in the tables.

Below are the steps to make a cut, and a video to show in real time. (Recommend watched in HD Mode, Full Screen)

1. Go to Settings > Advanced > Viewing > CPET
2. Activate “Test data editor”
3. Open the CPET test
4. Open the Test data editor on the right hand side
5. Select “Time” on the y-axis
6. Select “Interpolation for edit mode”
7. Move the cursor 1 in the graphic to the end of the real exercise
8. Move the cursor 2 in the graphic to the last point in the graphic
9. Make sure with the arrow controls of “Value 2”, that it is the last breath of the test
10. Enter for “Value 2” the value of “Value 1” + 1
11. Make a note of this value for later.
12. Press “Perform interpolation”
13. Press "Accept"
14. Open the Test data editor on the right hand side again
15. Select “Time” on the y-axis
16. Select “Edit Value for edit mode”
17. Move the cursor 1 in the graphic to the end of the real exercise
18. Make sure with the arrow controls of “Value 1”, that it is the last breath of the test
19. Enter for “Value 1” the value of “Value 2” that you made a note of
20. Press "Accept"