Obstructions in the Flow tube set or the Flow Sensor are usually caused by excess water vapour. The best way to clear a water vapour obstruction is to utilise air pressure.
Simple water vapour blockages may be cleared using compressed air, such as the gas used for calibration. Disconnect the gas supply line from the back of the Ergostik and use the gas pressure to blow through the holes in the flow tube set to clear any moisture. Always blow backwards down the tube set. i.e. from the leur lock fitting usually connected to the machine.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article